TM 5-1940-321-13&P
( 5 ) Wet craft thoroughly with the hose.
( 6 ) Using the bucket, brush and detergent, scrub all surfaces of the craft. Remove
all sand and dirt from areas adjacent to the inflatable keel. Pay particular
attention to removing sand and dirt from corners and the areas where the
buoyancy tubes and floor fabric join.
( 7 ) Use the hose to direct pressure water over the craft to remove all detergent.
( 8 ) Allow the craft to drain before removing it from its vertical position.
b. Reassemble Craft
( 1 ) Reinstall flooring. Refer to chapter 2, paragraph 2-8b got installation of rollup
flooring.
( 2 ) Reinflate keel to 220- 230 mb (3.2-3.3 psi). Refer to paragraph 2-3b.
( 3 ) Reinstall outboard engine and fuel tanks (refer to chapter 4, paragraph 4-3c).
INTERCOMMUNICATING VALVE CLEANING AND LUBRICATING
Tools and Materials Required (see Figure 5-2):
Brush, Wire (toothbrush style)
Brush, Wire, 3/4 inch diameter
Brush, Double-ended, Gun Bore
Lubricant, Marine Grease, OMC Triplegaurd
Nut Driver, 10 mm Deep-Well socket
Pliers, Needle Nose, medium size
Screwdriver, Flat-tip, 1/8-inch wide
Spanner, Collar Nut
Spanner, Half-Moon
Tray with 4 partitioned sections
Solvent, Toluene
Towels, Paper, Shop, Lint Free
Spanner, Valve Flywheel
5-12