TM 5-3990-264-13&P
0022
DISASSEMBLY
NOTE
All four stanchion pins are disassembled the same way. Left side is shown.
1.
Spread ring pin (Figure 1, Item 5) apart and remove from wire rope (Figure 1, Item 9).
2.
Remove wire rope (Figure 1, Item 9) from retaining ring (Figure 1, Item 10). Discard wire rope.
3.
Remove wire rope (Figure 1, Item 3) from retaining ring (Figure 1, Item 10). Discard wire rope.
END OF TASK
CLEANING
Refer to General Maintenance Instructions (WP 0017) for general cleaning instructions.
END OF TASK
INSPECTION
Refer to General Maintenance Instructions (WP 0017) for general inspection instructions.
END OF TASK
ASSEMBLY
NOTE
All four stanchion pins are assembled the same way. Left side is shown.
1.
Manufacture wire rope (Figure 2, Item 9) per (WP 0035) and install on retaining ring (Figure 2, Item 10).
Finished length is 16 inches (41 cm).
7
10 6
4
8
9
1
2
5
3
Figure 2. Pin Installation.
2.
Manufacture wire rope (Figure 2, Item 3) per (WP 0035) and install on retaining ring (Figure 2, Item 10) .
Finished length is 12 inches (30 cm).
3.
Spread ring pin (Figure 2, Item 5) on wire rope (Figure 2, Item 9).
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M06006)